The DJM Filter (vst2) has just stopped working mid set in Ableton Live v11.2.5. In this state, whenever the filter parameter moves into Low Pass-On bounds, the sound entirely cuts out, it outputs silence. If the filter is in middle/inactive or in High-Pass-On, the plugin continues to work.
This immediately & identically affected two instances in the same set, but a third instance was left unaffected. When I saved and reloaded the Live set, the plugin worked again.
I'm preparing for a live performance using the plugin, so it's concerning.
Extremely high input gain can derail the filter. If you are keeping your signal below 0 dB then you should have no issue. You could put a limiter or clipper before to ensure that.
I've added an internal clipper (at +12 dB input) in to the next version which should prevent the DSP from being able to derail, even with high filter drive, so putting a limiter or clipper before the filter should not be needed.
However it's considered beta and not on the freeware page as of now, due to added VST3 version and not a ton of testing yet.